Red dots with direct fit for CZ Shadow 2 Carry

Red dots with direct fit for CZ Shadow 2 Carry bolt directly to the Optics Ready slide—no adapter plate—so the dot rides lower, locks up rigidly, and co-witness is easier to achieve.

Applies only to models with a factory direct-fit cut. Pros: no plate and a lower sight height. Cons: you’re limited to red dots that share this exact footprint.

Common footprints for direct fit

• Shield RMSc footprint
• Holosun K-series footprint
• Leupold DPP footprint

Setup essentials

• Degrease interfaces and screws; apply Loctite threadlocker.
• Torque to spec for slide-to-optic screws; re-check after your first range session.
• Verify screw length & pitch for your specific slide (no internal interference).

Compatibility with other CZ Optics Ready models

If your CZ isn’t cut for a direct-fit optic, use Optics Ready plates to mount a wider range of red dots.

Not Optics Ready?

Your pistol can still run a red dot—use a dovetail red dot mount that replaces the rear sight (no slide milling required).