CZ P-07 red dot mounts swap into the rear-sight dovetail so you can add a red dot to a non-Optics Ready P-07—no slide milling and fully reversible.
Why mount on the P-07?
-
Keep the slide original: upgrade to a dot without machining or refinish work.
-
Prove the setup first: test optic models/positions, then swap back to irons in minutes.
-
Carry-aware: compact mounts and optics help preserve balance and holster fit.
Footprints commonly supported
- Trijicon RMR footprint
- Shield RMSc footprint
- Holosun K-series footprint
- Leupold DPP footprint
- C-More RTS footprint
- Vortex Venom / Docter footprint
- Aimpoint ACRO footprint
Install checklist
- Degrease interfaces and screws; apply Loctite threadlocker.
-
Torque to spec for mount-to-slide and optic-to-mount screws; re-check after your first range session.
- Verify screw length & pitch so nothing protrudes into the slide channel.
Model notes
If you also run an Optics Ready CZ, a plate gives a lower, more rigid interface—see Optics Ready plates. Direct-fit CZs like Shadow 2 Carry and P-09 Nocturne accept RMSc / Holosun K-series dots without a plate.
Sold out
