CZ 75 SP-01 Phantom red dot mounts

CZ 75 SP-01 Phantom red dot mounts replace the rear sight in the dovetail so you can add an optic to the polymer-framed Phantom—no slide cutting and fully reversible.

Why on the Phantom?

• Keep the slide original: mount a dot without permanent work or refinishing.
• Trial & tune: experiment with optic models/positions, then swap back to irons in minutes.
• Solid interface: model-specific dovetail fit designed to stay tight through training.

Footprints commonly supported

• Trijicon RMR footprint
• Shield RMSc footprint
• Holosun K-series footprint
• Leupold DPP footprint
• C-More RTS footprint
• Vortex Venom / Docter footprint
• Aimpoint ACRO footprint

Install checklist

• Degrease interfaces and screws; apply Loctite threadlocker.
• Torque to spec for mount-to-slide and optic-to-mount screws; re-check after your first range session.
• Verify screw length & pitch so nothing protrudes into the slide channel.

Using an Optics Ready CZ too?

OR slides use plates for a lower, more rigid interface—see Optics Ready plates. For other non-OR models, browse all dovetail red dot mounts.